Schematic Reference: Interior Lights Schematics

Connector End View Reference: Master Electrical Component List in Wiring Systems

Did you perform the Diagnostic System Check - Vehicle?

Go to Step 2

Go to Diagnostic System Check - Vehicle in Vehicle DTC Information

1. Turn the ignition to the ON position.
2. Close all the doors and turn the instrument panel (I/P) dimmer switch to the OFF position.

Are the courtesy lamps OFF?

Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems

Go to Step 3

1. Install a scan tool.
2. Turn ON the ignition , with the engine OFF.
3. With a scan tool, observe the Courtesy Switch Input circuit status.

Is the Courtesy Switch Input circuit ON?

Go to Step 4

Go to Step 5

1. Disconnect the headlamp switch connector.
2. With a scan tool, observe the Courtesy Switch Input circuit status.

Is the Courtesy Switch Input circuit ON?

Go to Step 9

Go to Step 12

With a scan tool, observe the Driver Door Switch Input circuit status.

Is the Driver Door Switch Input circuit open?

Go to Step 6

Go to Step 7

1. Disconnect the LF door lock connector.
2. With a scan tool, observe the Driver Door Switch Input circuit status.

Is the Courtesy Switch Input circuit open?

Go to Step 10

Go to Step 13

With a scan tool, observe the Door Jamb Input circuit status.

Is the Door Jamb Input circuit open?

Go to Step 8

Go to Step 15

1. Disconnect each door lock connector one at time.
2. With a scan tool, observe the Door Jamb Input circuit status as each door lock connector is disconnected.

Does the Courtesy Switch Input circuit turn OFF when the door lock connectors are disconnected?

Go to Step 14

Go to Step 11

Test for a short to ground on the courtesy lamps control circuit. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 16

Go to Step 15

Test for a short to ground on the door unlatch switch signal circuit. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 16

Go to Step 15

Test for a short to ground on the door ajar switch signal circuit. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 16

Go to Step 15

Replace the headlamp switch. Refer to Headlamp Switch Replacement .

Did you complete the repair?

Go to Step 16

--

Replace the drivers door lock switch. Refer to Front Side Door Lock Replacement in Doors.

Did you complete the repair?

Go to Step 16

--

Replace the inoperative door lock switch. Refer to Front Side Door Lock Replacement or Rear Door Lock Replacement in Doors.

Did you complete the repair?

Go to Step 16

--

Replace the body control module (BCM). Refer to Diagnostic System Check - Vehicle in Computer/Integrating Systems for replacement, setup and programming.

Did you complete the repair?

Go to Step 16

--

Operate the system in order to verify the repair.

Did you correct the condition?

System OK

Go to Step 2