To operate the windshield wipers turn the band located on the multifunction
lever upward or downward.
WIPER: Turn this band to control the windshield wipers.
OFF: Turn the band to OFF to turn off the windshield wipers.
LO (Low Speed): Turn the band away from you to LO and past the
delay settings for steady wiping at low speed.
HI (High Speed): Turn the band away from you, to HI, and past
the delay settings for steady wiping at a high speed.
(Delayed Wiping): Turn the band away from you, just past OFF,
to one of the five delayed settings, to choose the length of intervals between each
wiping cycle. The further the band is turned upward, toward LO, the shorter the delay
will be. Select one of these settings for light rain or snow.
MIST: Turn the band to MIST for a single wiping cycle. Hold
it until the windshield wipers start. Then let it go. The windshield wipers will stop
after one wipe. If more wipes are needed, hold the band on MIST longer.
Be sure to clear ice and snow from the windshield wiper blades before using
them. If they are frozen to the windshield, carefully loosen or thaw them. If the
blades do become worn or damaged, get new blades or blade inserts. See
Windshield Wiper Blade Replacement
.
Heavy snow or ice can overload the wipers. A circuit breaker will stop them
until the motor cools. Clear away snow or ice to prevent an overload.