The Remote Keyless Entry (RKE) transmitter functions will work up to 195 feet
(60 m) away, however, the operating range may be less while the vehicle is running.
There are other conditions which can affect the performance of the transmitter.
See
Remote Keyless Entry (RKE) System
.
With Remote Start Shown, Without Remote Start Similar
(Remote Vehicle Start): If your vehicle has this feature,
press to start the engine from outside the vehicle using the RKE transmitter.
See
Remote Vehicle Start
for additional
information.
[block ] (Lock): Press to lock all the doors. If enabled through
the Driver Information Center (DIC), the parking lamps may flash once to indicate
locking has occurred, or the horn may chirp when [block ] is pressed again within five
seconds from the previous press of the lock button. See "FOB LOCK FEEDBACK"
under
DIC Vehicle Personalization
for additional
information. If the vehicle has the content theft-deterrent system, pressing [block ]
may also arm it. See
Content Theft-Deterrent
.
(Unlock): Press to unlock the driver's
door. If is pressed again within five seconds, all remaining doors will
unlock. The interior lamps will come on and stay on for 20 seconds or until
the ignition is turned on. If enabled through the DIC, the parking lamps can be programmed
to come on for a set amount of time when the vehicle is unlocked using the RKE transmitter.
See "EXT (Exterior) LIGHT DELAY" under
DIC Vehicle Personalization
. If the vehicle has the content theft-deterrent
system, pressing on the RKE transmitter may disarm it. See
Content Theft-Deterrent
.
(Remote Trunk Release): Press and hold for about
one second to release the trunk lid. The transmission must be in PARK (P) for this
feature to operate.
(Panic Alarm): Press to activate the alarm.
The headlamps will flash and the horn will sound repeatedly for two minutes. The alarm
will turn off when the ignition is moved to ON/RUN or is pressed again. The
ignition must be in LOCK/OFF or ACC/ACCESSORY for the alarm to work.
Matching Transmitter(s) to Your Vehicle
Each RKE transmitter is coded to prevent another transmitter from unlocking
your vehicle. If a transmitter is lost or stolen, a replacement can be purchased through
your dealer/retailer. All transmitters need to be re-coded to match the new transmitter.
The lost transmitter will no longer work after the new transmitters are re-coded.
The vehicle can have a maximum of four transmitters matched to it.
Battery Replacement
Replace the battery if the KEY FOB BATT LOW message displays in the DIC. See "KEY
FOB BATTERY LOW" under
DIC Warnings and Messages
for additional information.
Notice: When replacing the battery, do not touch
any of the circuitry on the transmitter. Static from your body could damage the transmitter.
To replace the battery in the RKE transmitter:
- Separate the halves of the transmitter with a flat, thin object inserted
into the notch on the side.
- Remove the old battery. Do not use a metal object.
- Insert the new battery, positive side facing up. Replace with a CR2032
or equivalent battery.
- Put the transmitter back together tightly.