For 1990-2009 cars only
Removal Procedure
- Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
- Remove the bearing/hub assembly. Refer to Front Wheel Bearing and Hub Replacement .
- Disconnect the front lower control arm ball stud. Refer to Lower Control Arm Replacement .
- Disconnect the outer tie rod end from the steering knuckle. Refer to Rack and Pinion Outer Tie Rod End Replacement .
- Scribe the strut to the knuckle.
- Remove the bolts and nuts attaching the strut to the knuckle.
- Remove the knuckle from the vehicle.
Installation Procedure
- Install the knuckle to the vehicle.
- Install the through bolts and nuts attaching the strut to the knuckle.
- Connect the outer tie rod to the steering knuckle. Refer to Rack and Pinion Outer Tie Rod End Replacement .
- Connect the front lower control arm ball stud to the knuckle. Refer to Lower Control Arm Replacement .
- Install the front wheel drive shaft bearing. Refer to Front Wheel Bearing and Hub Replacement .
- Lower the vehicle.
- Inspect the front wheel alignment and adjust if necessary. Refer to Wheel Alignment Measurement .
Notice: Refer to Fastener Notice in the Preface section.
Tighten
Tighten the through bolts and nuts to 120 N·m
(89 lb ft).
