Removal Procedure
Caution: This vehicle is equipped with a Supplemental Inflatable Restraint (SIR) System. Failure to follow the correct procedure could cause the following conditions:
⢠| Unnecessary SIR system repairs |
In order to avoid the above conditions, observe the following guidelines:
⢠| Refer to SIR Component Views in order to determine if you are performing service on or near the SIR components or the SIR wiring. |
⢠| If you are performing service on or near the SIR components or the SIR wiring, disable the SIR system. Refer to Disabling the SIR System. |
- Disable the SIR system.
Refer to
Disabling the SIR System
in
SIR.
- Remove the steering wheel. Refer to
Steering Wheel Replacement
.
- Remove the steering wheel
rear bezel retaining screws (1).
- Remove the steering wheel rear bezel (2).
- Insert a small, blunt
ended tool into the access hole in the back of the steering wheel in order
to push the switch out of the steering wheel.
- Disconnect the electrical connector.
Installation Procedure
- Connect the electrical
connector.
- Align the switch to the switch opening in the steering wheel.
- Snap the switch into the steering wheel.
- Install the steering wheel
rear bezel (2).
Notice: Use the correct fastener in the correct location. Replacement fasteners
must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant
are identified in the service procedure. Do not use paints, lubricants, or
corrosion inhibitors on fasteners or fastener joint surfaces unless specified.
These coatings affect fastener torque and joint clamping force and may damage
the fastener. Use the correct tightening sequence and specifications when
installing fasteners in order to avoid damage to parts and systems.
- Install the steering
wheel rear bezel retaining screws (1).
Tighten
Tighten the steering wheel rear bezel retaining screws to 3 NĀ·m
(26 lb in).
- Install the steering wheel. Refer to
Steering Wheel Replacement
.
- Enable the SIR system. Refer to
Enabling the SIR System
in SIR.