FUSE PANEL OPENS ON BUMPS REPOSITION FUSE BLOCK PANEL

SUBJECT: FUSE PANEL OPENS ON BUMPS OR WITH PARK BRAKE RELEASE

MODELS AFFECTED: 1991 PARK AVENUE/PARK AVENUE ULTRA MODELS

CONDITION:

---------- Some reports have been received of the fuse panel falling open on bumps and in some cases, as the park brake release handle is actuated.

CORRECTION:

------------ The condition stated above can be corrected as follows:

1. Lower the fuse block by pinching the release tabs.

2. Locate the fuse block retention stud. (See Figure 1) The stud can be seen looking upward through the opening that the fuse block normally occupies when in the closed position.

3. Using a 10 mm socket, loosen the nut which secures the fuse block bracket to the stud. With the nut loosened, push the entire fuse block bracket as far forward as possible. Hold the bracket in the forward position and tighten the nut 8-11 N.m (10-14 ft.lbs.). If necessary, reattach the fuse block retainer to the bracket by snapping the retainer over the ears of the bracket. Return the fuse block to the closed position.

WARRANTY INFORMATION:

Labor Operation No.: T5210 Labor Time: .2 hour Trouble Code: 92

General Motors bulletins are intended for use by professional technicians, not a "do-it-yourselfer". They are written to inform those technicians of conditions that may occur on some vehicles, or to provide information that could assist in the proper service of a vehicle. Properly trained technicians have the equipment, tools, safety instructions and know-how to do a job properly and safely. If a condition is described, do not assume that the bulletin applies to your vehicle, or that your vehicle will have that condition. See a General Motors dealer servicing your brand of General Motors vehicle for information on whether your vehicle may benefit from the information.