Assembly Procedure
- Install the ignition and key alarm switch assembly (2) and secure by using 2 tapping screws (3).
- Install the control coded key (2) onto the lock module assembly (1).
- Connect the connectors (1) of the ignition and key alarm switch assembly
- Install 1 wire harness strap (2) onto the upper tilt head assembly (1).
- Install the upper and lower shrouds. Refer to Steering Column Trim Covers - Assemble - Off Vehicle .
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Install the key alarm connector (1) onto the lock module assembly (4).
Tighten
Tighten the screws to 7 N·m (62 lb in).
Install 3 wire harness straps (3) onto the wire harness assembly (4).
Install the wire harness assembly (4) into the wire harness strap (5).
