Step
| Action
| Value(s)
| Yes
| No
|
1
| Did you
perform the Fuel Filler Door Release System Check?
| --
| Go to
Step 4
| Go to
Fuel Filler Door Release System Check
|
2
|
- Disconnect the fuel door release actuator connector.
- Connect a J 39200
digital multimeter (DMM) between terminal B and ground.
Is the measured voltage within the specified range?
| 10-15 V
| Go to
Step 4
| Go to
Step 3
|
3
| Inspect the TRUNK
REL fuse.
Is the fuse OK?
| --
| Go to
Step 11
| Go to
Step 12
|
4
|
- Connect a DMM between the fuel door release actuator connector
terminals A and B.
- Press the fuel door release switch.
Is the measured voltage within the specified range?
| 10-15 V
| Go to
Step 5
| Go to
Step 6
|
5
|
- Inspect the fuel door release actuator connector for poor
terminal contact.
- If the contact is OK, replace the fuel door release actuator.
Refer to
Fuel Tank Filler Door Lock Actuator Replacement
.
Is the repair complete?
| --
| Go to
Step 13
| --
|
6
|
- Disconnect the fuel door release switch connector.
- Use a DMM in order to measure the resistance between switch connector
terminal B and ground.
Is the resistance less than the specified value?
| 5 ohms
| Go to
Step 8
| Go to
Step 7
|
7
| Repair the
open in CKT 450 (BLK).
Is the repair complete?
| --
| Go to
Step 13
| --
|
8
|
- Connect a fused jumper across the fuel door release switch connector
terminals A and B.
- Use a DMM in order to measure the resistance between the fuel
door release actuator connector terminal A and ground.
Is the resistance less than the specified value?
| 5 ohms
| Go to
Step 9
| Go to
Step 10
|
9
|
- Inspect the fuel door release switch connector for poor
terminal contact.
- If the contact is OK, replace the fuel door release switch. Refer
to
Fuel/Rear Compartment Release Switch Replacement
.
Is the repair complete?
| --
| Go to
Step 13
| --
|
10
| Repair CKT 79 (PNK).
Is the repair complete?
| --
| Go to
Step 13
| --
|
11
| Repair the open in CKT 1140 (ORN).
Is the repair complete?
| --
| Go to
Step 13
| --
|
12
|
- Repair the short to ground in CKT 1140 (ORN).
- Replace the TRUNK REL fuse.
Is the repair complete?
| --
| Go to
Step 13
| --
|
13
|
- Ensure that any of the components removed during diagnosis are
installed in place.
- Ensure that all of the connectors are connected.
- Repeat the system check. Refer to
Fuel Filler Door Release System Check
.
Is the system check complete?
| --
| System OK
| --
|
