Removal Procedure
Caution: This vehicle is equipped with a Supplemental Inflatable Restraint (SIR) System. Failure to follow the correct procedure could cause the following conditions:
⢠| Unnecessary SIR system repairs |
In order to avoid the above conditions, observe the following guidelines:
⢠| Refer to SIR Component Views in order to determine if you are performing service on or near the SIR components or the SIR wiring. |
⢠| If you are performing service on or near the SIR components or the SIR wiring, disable the SIR system. Refer to Disabling the SIR System. |
- Disable the SIR system.
Refer to
Disabling the SIR System
in
SIR.
- Remove the steering column trim covers. Refer to
Steering Column Trim Covers Replacement - On Vehicle
.
- Remove the wire harness
assembly (4) out of the wire harness strap (5).
- Remove the wire harness straps (3) from the wire harness assembly.
- Remove the wire harness strap (2) from the upper tilt head assembly
(1).
- Disconnect the ignition switch electrical connector.
- Remove the theft deterrent
module (2) from the lock module assembly.
- Remove the key alarm connector
(1) from the lock module assembly (4).
- Remove the ignition switch retaining screws (3).
- Remove the ignition switch.
Installation Procedure
- Install the ignition switch
(2) to the steering column.
Notice: Use the correct fastener in the correct location. Replacement fasteners
must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant
are identified in the service procedure. Do not use paints, lubricants, or
corrosion inhibitors on fasteners or fastener joint surfaces unless specified.
These coatings affect fastener torque and joint clamping force and may damage
the fastener. Use the correct tightening sequence and specifications when
installing fasteners in order to avoid damage to parts and systems.
- Install the ignition
switch retaining screws (3).
Tighten
Tighten the ignition switch retaining screws to 7 NĀ·m (62 lb in).
- Install the key alarm connector (1) to the lock module assembly
(4).
- Install the theft deterrent
module (2) to the lock module (1).
- Route the electrical harness and connect electrical connections.
- Install a new wire harness
strap to the upper tilt head assembly (2).
- Install new wire harness straps to the wire harness assembly (3).
- Install the wire harness assembly into the wire harness strap
(5).
- Install steering column trim covers. Refer to
Steering Column Trim Covers Replacement - On Vehicle
.
- Enable the SIR system. Refer to
Enabling the SIR System
in SIR.