- When you install power seat adjusters, verify that both adjusters
are parallel and in phase with each other. Both adjusters reach their maximum
horizontal or vertical travel in a given direction at the same time if
the adjusters are in phase with each other.
- If the adjusters are out of phase, perform the following adjustment:
| 2.1.1. | Operate the seat control switch until 1 adjuster reaches
the full-forward position. |
| 2.1.2. | Detach the horizontal drive cable from the adjuster which has
reached the full forward position. |
| 2.1.3. | Operate the seat forward until the other adjuster
reaches the full-forward position. |
| 2.1.4. | Connect the horizontal drive cable. |
| 2.1.5. | Operate the seat in order to verify for correct horizontal travel. |
| 2.2. | Front or Rear Vertical Travel |
| 2.2.1. | Operate the seat control switch until 1 adjuster has reached
the fully-raised position at both the front and the rear vertical travel limits. |
| 2.2.2. | Disconnect both of the vertical drive cables (2) from the
adjuster which has reached the fully-raised position. |
| 2.2.3. | Operate the seat control switch until the other adjuster reaches
the fully-raised position at both the front and the rear vertical travel limits. |
| 2.2.4. | Connect the previously removed front and rear vertical drive cables (2). |
| 2.2.5. | Test the vertical travel by operating the adjusters through one
or two complete cycles. |
| 2.2.6. | Repeat this procedure as required if the adjusters are still out
of phase after the test cycle. |
