For 1990-2009 cars only
Removal Procedure
- Remove the door trim panel. Refer to Rear Side Door Trim Panel Replacement .
- Peel the water deflector down far enough to access the inside of the door latch. Refer to Rear Side Door Water Deflector Replacement .
- Disconnect the outside door handle rod from the door latch.
- Remove the plugs (1).
- Remove the fasteners from the handle assembly.
- Gently flex the lower tabs upwards in order to allow the handle to disengage from the outer door panel flange.
- Remove the outside door handle.
- Remove the rod from the handle.
Important: Ensure that the window is in the full-up position.
Installation Procedure
- Insert the top of the outside handle (1) into the door.
- Apply pressure at the lower portion of the handle assembly to snap the tabs (2) into place.
- Install the door handle fasteners.
- Install the outside door handle rod to the door latch.
- Install the fastener access hole plugs.
- Install the water deflector. Refer to Rear Side Door Water Deflector Replacement .
- Install the trim panel. Refer to Rear Side Door Trim Panel Replacement .
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the fasteners to 7 N·m (62 lb in).
