Power Seat Switch Bezel Pops Out, Trim Comes Off (Install Retainer to Bezel)

Some customers may comment that the trim around the power seat switch is coming off.

The bezel retaining clip may be pulling out of the seat frame.

Install the retainer (barrel style) to the top post on the seat bezel.

1. Remove the switch bezel. Pull outward on the side of the switch plate.
2. Disconnect the electrical connector from the seat harness.
3. Remove the switch from the bezel. Use a flat bladed screw driver to release the retaining tabs.
4. Use a 5/16-24  die to thread the upper rear locator post.



5. Install the retainer (barrel style) clip onto the threaded locator post. Press it on until it is flush with the top of the post. Then, with a deep well 8 mm socket and hammer, tap the retainer on to the retainer post until the clip hits the bottom of the post .



6. Glue the retainer (barrel style) clip to the post using Instant Gel Adhesive or equivalent.



7. Use a 3/8 inch drill bit to drill out the upper rearward locator hole in the seat.
8. Install the power seat switch to the bezel.
9. Install the bezel to the seat.

Parts are currently available from GMSPO.

For vehicles repaired under warranty, use: