Removal Procedure
- Remove the Brake pedal Refer to Brake Pedal Replacement
- Remove the wiring harness clips from the bracket (3).
- Remove the brake pedal bracket upper mounting nuts to cross car beam.
- Remove the brake pedal bracket upper mounting bolts to cross car beam.
- Remove the brake pedal bracket lower mounting bolts to reinforcement bracket.
- Remove the brake pedal bracket.
- Inspect all components for wear. Repair or replace the worn parts as necessary.
Installation Procedure
- Install the brake pedal bracket (1).
- Install the brake pedal bracket lower mounting bolts to the reinforcement bracket.
- Install the brake pedal upper mounting bolts to the cross car beam.
- Install the brake pedal bracket upper mounting nuts to the cross car beam.
- Install the Brake pedal. Refer to Brake Pedal Replacement .
- Install the wiring harness clips to the bracket.
- Adjust the stoplamp switch. Refer to Stop Lamp Switch Adjustment .
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the bolts to 22 N·m (16 lb ft).
Tighten
Tighten the upper mounting bolts to 25 N·m (18 lb ft).
Tighten
Tighten the nuts to 25 N·m (18 lb ft).
