GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Buick 🢒 1999 🢒 Regal 🢒 Body and Accessories 🢒 Doors 🢒 Rear Side Door Window Switch Replacement

Removal Procedure

    Important: When removing a door trim panel or switch plate, the ignition switch must be in the OFF position. This will eliminate the possibility of shorting out the switch if a flat-bladed tool, awl or metal object is used to remove the switch from the harness.

    Important: Use a protective coating/tape at the point of insertion of the flat surface tool. Damage to the inner door panel may occur if it is not protected.

  1. Insert a plastic flat-bladed tool at the rear edge of the switch bezel. Press forward in order to release the switch bezel retainers.

    2. Object Number: 325969 Size: SH
  2. Remove the switch from the bezel.
  3. Remove the switch from the bezel.

    4. Object Number: 325972 Size: SH
  4. Disconnect the electrical connector from the power window switch.
  5. Remove the switch from the door.

Installation Procedure

    Object Number: 325972 Size: SH
  1. Install the switch tabs into the bezel slots.
  2. Press down on the tabs in order to secure the switch.
  3. Connect the electrical connector to the window switch.

    4. Object Number: 325969 Size: SH
  4. Align the bezel to the door trim panel opening and press into place to secure.