Tools Required
J 39400-A Halogen
Leak Detector
Removal Procedure
- Recover the refrigerant. Refer to
Refrigerant Recovery and Recharging
.
- Remove the front fender upper diagonal. Refer to
Front Fender Upper Diagonal Brace Replacement
in Body Front
End.
- Remove the air cleaner assembly. Refer to
Air Cleaner Assembly Replacement
in Engine Controls-3.1L
or
Air Cleaner Assembly Replacement
in Engine Controls-3.8L.
- Remove the radiator. Refer to
Radiator Replacement
in Engine Cooling.
- Loosen the condenser tube
nut from the condenser.
- Disconnect the condenser
tube from the condenser.
- Remove the A/C compressor hose block fitting nut from the condenser.
- Disconnect the A/C compressor hose from the condenser.
- Tilt the top of the condenser
to the rear of the vehicle and lift up to remove the condenser.
- Ensure the lower rubber mounts stay in place in the vehicle.
- Remove the upper rubber mounts from the condenser.
Installation Procedure
- Install the upper rubber
mounts on to the condenser.
- Install the lower ends of the condenser in to the lower rubber
mounts.
Important: Ensure the upper rubber mounts stay in place on the condenser.
- Tilt the top of the condenser in to place.
Important: Coat the new O-ring seals with mineral base 525 viscosity refrigerant
oil.
- Install the new O-ring seals onto the A/C compressor hose and the condenser
tube. Refer to
O-Ring Replacement
.
- Connect the condenser
tube to the condenser.
Notice: Use the correct fastener in the correct location. Replacement fasteners
must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant
are identified in the service procedure. Do not use paints, lubricants, or
corrosion inhibitors on fasteners or fastener joint surfaces unless specified.
These coatings affect fastener torque and joint clamping force and may damage
the fastener. Use the correct tightening sequence and specifications when
installing fasteners in order to avoid damage to parts and systems.
- Tighten the condenser tube nut.
Tighten
Tighten the nut to 27 N·m (20 lb ft).
- Connect the A/C compressor
hose to the condenser.
- Install the A/C compressor hose block fitting nut ot the condenser.
Tighten
Tighten the nut to 16 N·m (12 lb ft).
- Install the radiator. Refer to
Radiator Replacement
in Engine Cooling.
- Install the front fender upper diagonal. Refer to
Front Fender Upper Diagonal Brace Replacement
in Body Front
End.
- Install the air cleaner assembly. Refer to
Air Cleaner Assembly Replacement
in Engine Controls-3.1L
or
Air Cleaner Assembly Replacement
in Engine Controls-3.8L .
- Evacuate and recharge the A/C system. Refer to
Refrigerant Recovery and Recharging
.
- Leak test the fittings of the component usingJ 39400-A
.