Tools Required

J 34730 Fuel Pressure Gauge

Caution: Provide proper ventilation when working with fuel in enclosed areas where fuel vapors can collect. The lack of adequate ventilation may result in personal injury.

Caution: Always wear safety goggles when working with fuel in order to protect the eyes from fuel splash.

Notice: Do Not handle the fuel sender assembly by the fuel pipes. The amount of leverage generated by handling the fuel pipes could damage the joints.

Notice: Clean all of the following areas before performing any disconnections in order to avoid possible contamination in the system:

1. Relieve the fuel system fuel pressure. Refer to Fuel Pressure Relief .
2. Drain the fuel tank (1) to at least 3/4 of a tank full. Refer to Fuel Tank Draining .

Important: The modular fuel sender support assembly will spring-up when the locking ring is moved.

3. Remove the fuel sender assembly. Refer to Fuel Sender Assembly Replacement .

1. Note the position of the fuel sender strainer for installation.
2. Support the reservoir with one hand and grasp the fuel sender strainer with the other hand.



3. Pull the external fuel sender strainer off of the fuel pump.
4. Inspect the fuel sender strainer. If the fuel sender strainer is contaminated, the fuel tank should be cleaned.
5. Discard the fuel sender strainer (1) after inspection.



6. Disassemble the electrical connectors from the sensor assembly of the fuel pump and the cover assembly.
7. Disassemble the fuel level sensor assembly.

1. Assemble the fuel level sensor assembly.
2. Connect the electrical connectors to the fuel pump and the cover assembly.
3. Position the new fuel sender strainer (1) on the modular fuel sender and push on the outer edge of the fuel sender strainer until the fuel sender strainer is fully seated.

1. Reinstall the fuel sender assembly. Refer to Fuel Sender Assembly Replacement .
2. Add fuel and reinstall the fuel tank filler pipe cap.
3. Connect the negative battery cable. Refer to

   Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.

   in Cautions and Notices.
4. Reinstall the rear lower seat cushion. Refer to Rear Seat Cushion Replacement .
5. Inspect for leaks.

5.1.	Turn the ignition switch On for 2 seconds.

5.2.	Turn the ignition switch Off for 10 seconds.

5.3.	Turn the ignition switch On.

5.4.	Check for fuel leaks.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

6. Reinstall the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement .



7. Reinstall the fuel sender access panel.

Tighten
Tighten the bolts to 2 N·m (18 lb in).

8. Reinstall the rear compartment floor trim. Refer to Compartment Close-Out Panel Replacement - Rear .