The front suspension is a combination of the strut and the spring design. The control arms pivot from the crossmember. Conventional rubber bushings are used for the lower control arm pivots. The upper end of the strut is isolated by a rubber mount. This contains a bearing in order to allow the wheel to turn.
The lower end of the steering knuckle pivots on a ball joint riveted to the control arm. The ball joint is fastened to the steering knuckle with a castellated nut and cotter pin. For suspension assembly components refer to Front Suspension Assembly (1)Bolt (2)Clamp, Stabilizer Shaft (3)Stabilizer Shaft (4)Nut, Stabilizer Link (5)Washer (6)Insulator, Stabilizer Link (6)Insulator, Stabilizer Link (5)Washer (7)Spacer Stabilizer Link (5)Washer (6)Insulator, Stabilizer Link (8)Bushing, Vertical (9)Bolt, Vertical Bushing (10)Ball Joint (11)Bolt, Stabilizer Link (5)Washer (6)Insulator, Stabilizer Link (12)Control Arm (13)Bushing, Control Arm (14)Lower Spring Insulator (15)Suspension Support (16)Insulator, Stabilizer Shaft (17)Cover, Strut Mount (18)Nut (19)Nut, Strut Dampener Shaft (20)Strut Mount and Rate Washer Assembly (21)Spring Seat (22)Upper Spring Insulator (23)Strut Bumper and Shield (24)Spring (25)Lower Spring Insulator (26)Strut (27)Nut (28)Washer (29)Bolt (30)Hub and Bearing Assembly (31)Seal (Part of 5) (32)Steering Knuckle (33)Nut, Ball Joint (34)Cotter Pin (35)Bolt (36)Bolt Front Suspension Assembly.
