Step
| Action
| Value(s)
| Yes
| No
|
1
| Was the Steering Wheel Control System Check performed?
| --
| Go to Step 2
| Go to
Steering Wheel Control System Check
|
2
| Are
all the radio functions operating normally at the radio?
| --
| Go to
Step 4
| Go to
Step 3
|
3
|
- Disconnect connector C415.
- Plug the dash harness radio connector into the radio (part of
C415).
- Turn the radio ON.
Are all the radio functions operational at the radio?
| --
| Go to
Step 5
| Go to
Step 6
|
4
|
- Disconnect the radio connector.
- Turn the ignition switch to the ON position.
- Turn the radio ON.
- Measure the voltage between radio connector, terminal 14
(Pontiac) or terminal E6 (Buick) and ground while operating each steering
wheel control button.
- Compare each voltage with the voltage specified.
Are the voltages within range?
| 0-5 V
| Go to
Step 7
| Go to
Step 8
|
5
| Repair CKT 1011 for the following conditions:
Refer to
Wiring Repairs
in
Wiring Systems.
Did you complete the repair?
| --
| Go to
Steering Wheel Control System Check
| --
|
6
| Service the radio.
Did you complete the repair?
| --
| Go to
Steering Wheel Control System Check
| --
|
7
|
- Inspect CKT 1011 for a poor connection at terminal 14
(Pontiac) or terminal E6 (Buick).
- If the circuit is OK, service the radio.
Did you complete the repair?
| --
| Go to
Steering Wheel Control System Check
| --
|
8
|
- Disable the SIR system. Refer to
Disabling the SIR System
in SIR.
- Disconnect and remove the inflator module from the steering wheel.
Refer to
Inflatable Restraint Steering Wheel Module Coil Replacement
in SIR.
- Disconnect the steering wheel control switches connector.
- Measure the resistance between steering wheel switches connector
terminal A and terminal C while operating each steering wheel
control button.
- Compare each resistance with the specified values.
Are the measured resistances approximately equal to the specified values?
|
• | Seek (Down) - 4282 ohms |
| Go to
Step 9
| Go to
Step 10
|
9
|
- Inspect CKT 43 for an open between the SIR coil assembly
connector terminal A and S227.
- Inspect CKT 1011 between SIR coil assembly connector terminal C
and radio connector terminal 14 (Pontiac) or terminal E6 (Buick)
for the following conditions:
Are the circuits good?
| --
| Go to
Step 11
| Go to
Step 12
|
10
| Replace the steering wheel control switches. Refer to
Steering Wheel Control Switches Replacement
.
Did you complete the repair?
| --
| Go to
Steering Wheel Control System Check
| --
|
11
| Service the radio.
Did you complete the repair?
| --
| Go to
Steering Wheel Control System Check
| --
|
12
| Repair the following components as needed:
• | Replace the coil assembly. Refer to the following procedures: |
Did you complete the repair?
| --
| Go to
Steering Wheel Control System Check
| --
|