Removal Procedure
- Remove the left sound insulator. Refer to
Instrument Panel Insulator Replacement
in Instrument Panel, Gauges, and Console.
- Disconnect the wiring harness connectors.
- Pull the clutch pedal switch (1) rearward in order to remove
the switch from the retainer in the bracket.
Installation Procedure
- Install the retainer into the bracket from the
forward side.
- Depress the clutch pedal.
- Insert the switch (1) into the retainer until the switch
seats on the retainer. You should hear an audible click as the ribbed portion
of the switch is pushed forward through the retainer.
- Connect the wiring harness to the clutch pedal switch (1).
- Use the following steps in order to adjust the switch:
| 5.1. | Pull the clutch pedal fully rearward against the pedal stop until
you cannot hear the clicks. |
| 5.2. | Move the switch in the retainer in order to adjust the switch. |
| 5.3. | Release the clutch pedal. |
| 5.4. | Repeat the procedure, if necessary, in order to properly adjust
the switch. |
- Connect the wiring harness connectors.
- Install the sound insulator. Refer to
Instrument Panel Insulator Replacement
in Instrument Panel, Gauges and Console.
