Step
| Action
| Value(s)
| Yes
| No
|
1
| Was the Charging System Check performed?
| --
|
Go to Step 2
| Go to
Charging System Check
|
2
|
- Disconnect generator connector C2.
- Attach a fused jumper from the generator connector C2 to ground.
- Turn the ignition switch to the ON position.
Is the charging indicator lamp illuminated?
| --
|
Go to Step 3
|
Go to Step
4
|
3
| Repair or replace the generator. Refer to
Generator Replacement
in Engine Electrical.
Is the repair or replacement complete?
| --
|
Go to Step 7
| --
|
4
|
- Disconnect connector C102.
- Attach a fused jumper between terminal 3 of connector C102 and
a known good ground.
Is the charging indicator lamp illuminated?
| --
|
Go to Step 5
|
Go to Step
6
|
5
|
- Locate an open or a high resistance in circuit PM1 between terminal
3 of connector C102 and the generator connector C2.
- Repair the open or the high resistance in circuit PM1 between
terminal 3 of connector C102 and the generator connector C2.
Is the repair complete?
| --
|
Go to Step
7
| --
|
6
|
- Locate an open or a high resistance in circuit PM1 between terminal
3 of connector C102 and terminal 18 of the gauge cluster connector.
- Repair the open or the high resistance in circuit PM1 between
terminal 3 of connector C102 and terminal 18 of the gauge cluster connector.
- Replace the gauge cluster if circuit PM1 is OK. Refer to
Instrument Cluster Replacement
in Instrument
Cluster, Gauges and Console.
Is the repair or replacement complete?
| --
|
Go to Step 7
| --
|
7
|
- Connect all of the connectors and components that were disconnected.
- Verify that the charging indicator operates properly.
Does the charging indicator lamp operate properly?
| --
| System OK
|
Go to Step 1
|
