Tools Required

1. Remove the rear axle cradle. Refer to Crossmember Replacement .
2. Remove the protective boot from the top of the support bushing. Pry the boot out by hand.



3. Use the legs of J 24319-B .
4. You may have to place a shim in the center of the bushing.
5. Press out the bushing.
6. Remove the rear axle support bushing.

1. Install the bushing to the cradle using the J 42090 .
2. Install the protective boot to the top of the support bushing.
3. Install the rear axle cradle. Refer to Crossmember Replacement .
4. Adjust the rear toe to specifications. Refer to Rear Toe Adjustment in Wheel Alignment.