Step
| Action
| Value(s)
| Yes
| No
|
1
| Did you perform the Exterior Lights Diagnostic System Check?
| --
| Go to
Step 2
| Go to
Exterior Lights System Check
|
2
|
- Disconnect the hazard warning switch.
- Use the DMM in order to measure the voltage between terminal 6
of the hazard warning switch connector and a known good ground.
Does the voltage measure near the specified value?
| B+
| Go to
Step 4
| Go to
Step
3
|
3
|
- Locate an open or a high resistance in CKT A9.
- Repair the open or the high resistance in CKT A9.
Did you complete the repair?
| --
| Go to
Step 7
| --
|
4
|
- Disconnect the turn signal lamp flasher K10.
- Use the DMM in order to measure the resistance between terminal 8
of the turn signal lamp flasher K10 connector and terminal 1 of the
hazard warning switch connector.
Does the resistance measure less than the specified value?
| 5 ohms
| Go to
Step 6
| Go to
Step 5
|
5
|
- Locate an open or a high resistance in CKT FM22.
- Repair the open or the high resistance in CKT FM22.
Did you complete the repair?
| --
| Go to
Step
7
| --
|
6
| Replace the hazard warning switch. Refer to
Instrument Panel Accessory Trim Plate Replacement
in Instrument Panel, Gauges and
Console.
Did you complete the repair?
| --
| Go to
Step
7
| --
|
7
|
- Connect all connectors and components that were previously disconnected.
- Verify that the hazard lamps operate properly.
Do the hazard lamps operate properly?
| --
| Go to
Exterior Lights System Check
| Go to
Step
1
|
