Was the Wiper/Washer System Check performed?

--

Go to Step 2

Go to Wiper/Washer System Check

1. Disconnect the windshield washer pump connector.
2. Use the DMM to measure the voltage between terminal 1 of the windshield washer pump and a known good ground.

Is the measured voltage within the specified value?

B+

Go to Step 3

Go to Step 4

1. Locate a short to B+ in circuits FA1, FA3, FA4, FA5 and/or FA80.
2. Repair the short to B+ in circuits FA1, FA3, FA4, FA5 and/or FA80.
3. If these circuits are OK, replace the windshield wiper and windshield washer switch. Refer to Windshield Wiper and Washer Switch Replacement - On Vehicle in Steering Wheel and Column On Vehicle Service.

Is the repair or replacement complete?

--

Go to Step 4

--

1. Connect all connectors and components that were disconnected.
2. Verify that the windshield washer pump operates properly.

Does the windshield washer pump operate properly?

--

System OK

Go to Step 1