Step
| Action
| Value(s)
| Yes
| No
|
1
| Was the Radio/Audio System Check performed?
| --
|
Go to Step 2
| Go to
Radio/Audio System Check
|
2
|
- Disconnect the radio connector.
- Turn ON the ignition with the engine OFF.
- Use the DMM to measure the voltage between terminal F1 of the
radio connector and a known good ground.
Is the measured voltage within the specified value?
| 10-13 V
|
Go to Step 4
|
Go to Step 3
|
3
| Locate and repair an open or high
resistance condition in the battery feed circuit.
Is the repair complete?
| --
|
Go to Step
7
| --
|
4
|
- Measure the resistance between terminal E16 and a known good ground.
- Measure the resistance between terminal F5 and a known good ground.
Is the measured resistance less than the specified value?
| .5 ohms
|
Go to Step 6
|
Go to Step 5
|
5
| Locate and repair an open or high
resistance condition in the radio ground circuit.
Is the repair complete?
| --
|
Go to Step
7
| --
|
6
|
- Replace the radio and perform the set up procedure.
- Install the scan tool.
- Select RADIO THEFT from the SPECIAL FUNCTIONS menu.
- Follow the instructions on the screen.
Did you complete the replacement?
| --
|
Go to Step
7
| --
|
7
|
- Connect all connectors and components that were disconnected.
- Verify that the radio operates properly.
Is the radio operating properly?
| --
| System OK
|
Go to Step
2
|
