Step
| Action
| Value(s)
| Yes
| No
|
1
|
- Turn the ignition switch to the ON position.
- Program the sun roof actuator. Refer to Programming the Sun Roof
Actuator for programming procedures.
- Turn the sun roof switch knob to position A. The sun roof should
move to the fully open position.
- Turn the sun roof switch knob to position C. The sun roof should
close approximately 50%.
- Turn the sun roof switch knob to position E. The sun roof should
move to the fully closed position.
- Turn the sun roof switch knob to position G. The sun roof should
move to the fully tilted position.
Does the sun roof move to the different positions when the sun roof
switch knob is moved to the different positions?
| --
|
Go to Step 2
| Go to
Power Sunroof Inoperative
|
2
|
- Turn the sun roof switch knob to position A and wait until the
sun roof is completely open.
- Turn the sun roof switch knob to position E so that the sun roof
will move to the fully closed position.
- As the sun roof is closing, use something to obstruct the sun
roof from fully closing.
- When the sun roof actuator detects that there is an obstruction,
it is supposed to stop and open to a predetermined position.
Does the sun roof actuator detect the obstruction and does it open to
a predetermined position?
| --
|
Go to Step 3
| Go to
Power Sunroof Pinch Guard Inoperative
|
3
|
- With all of the doors closed, operate the sun roof to any desired
position.
- As the sun roof is moving, open any door.
- When any door is opened, terminal 3 of the sun roof actuator
is grounded through the side door jamb switch.
- When the sun roof actuator senses that a door is open, it should
stop moving immediately.
Does the sun roof stop moving when any door is opened?
| --
|
Go to Step 5
|
Go to Step 4
|
4
|
- Locate an open or a high resistance in CKT R700.
- Repair the open or the high resistance in CKT R700.
- If circuit R700 is OK, replace the sun roof actuator. Refer to
Sunroof Actuator Replacement
.
Did you complete the repair?
| --
| System OK
| --
|
5
|
- Install the scan tool.
- Establish communication with the sun roof actuator.
Does the scan tool communicate with the sun roof actuator?
| --
|
Go to Step 6
| Go to
Scan Tool Does Not Communicate with Sunroof Actuator
|
6
| Are there any current and/or history and/or intermittent DTCs present?
| --
|
Go to Step 8
|
Go to Step 7
|
7
| Is the problem
intermittant?
- There may be an intermittent problem with the sun roof actuator
cables and/or linkages.
- The linkages and the cables may not be properly lubricated.
- Refer to
Lubrication Description
for lubricating procedures.
Did you complete the repair?
| --
| System OK
| --
|
8
| If DTC 50, 51 or 55 is set, the sun roof actuator will
become inoperative. Refer to
DTC 050, 051, or 055
for diagnosis.
Did you complete the repair?
| --
| System OK
| --
|