Removal Procedure
- Remove the rear window sunshade. Refer to Rear Sunshade Replacement .
- Remove rear window sunshade flywheel screw (3).
- Remove rear window sunshade transmission flywheel from the sunshade motor.
- Disconnect the sunshade motor electrical connector.
- Remove three screws and rear window sunshade motor from the sunshade assembly.
Installation Procedure
- Install the rear window sunshade motor to the sunshade assembly.
- Install the sunshade motor screws.
- Connect the sunshade motor electrical connector.
- Install rear the window sunshade transmission flywheel by:
- Install the sunshade transmission flywheel screw.
- Install the rear window sunshade. Refer to Rear Sunshade Replacement .
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the sunshade motors screws until fully seated but DO NOT strip.
| 4.1. | Turn sunshade motor clockwise untill the motor stops. |
| 4.2. | Install sunshade transmission flywheel (2), it maybe necessary to turn the flywheel counter-clockwise until it egages on to the motor shaft (1). |
Tighten
Tighten the sunshade transmission flywheel screw until fully seated
but DO NOT strip.
