Step
| Action
| Value(s)
| Yes
| No
|
1
| Was the Audible Warning System Check performed?
| --
|
Go to Step 2
| Go to
Audible Warnings System Check
|
2
|
- Remove the CLAMP W PBSL Fuse.
- Remove the ignition key from the ignition switch.
- Use the DMM to measure the voltage between the input of the CLAMP
W PBSL Fuse and a known good ground.
Is the measured voltage within the specified value?
| 0 V
|
Go to Step 4
|
Go to Step 3
|
3
|
- Locate a short to B+ in circuit A19.
- Repair the short to B+ in circuit A19.
- If this circuit is OK, replace the ignition switch. Refer to
Ignition Switch Replacement - On Vehicle
in Steering Wheel and Column On
Vehicle Service.
Is the replacement complete?
| --
|
Go to Step
5
| --
|
4
|
- Locate a short to B+ in the key-in positive voltage circuit.
- Repair the short to B+ in the key-in positive voltage circuit.
Is the repair or replacement complete?
| --
|
Go to Step 5
| --
|
5
|
- Connect all connectors and components that were disconnected.
- Verify that the key-in warning operates properly.
Does the key-in warning operate properly?
| --
| System OK
|
Go to Step 1
|
