Notice: Refer to Fastener Notice in the Preface section.

Fastener Tightening Specifications: Refer to Fastener Tightening Specifications .

Preliminary Procedures

1. Remove the wiper arms. Refer to Windshield Wiper Arm Replacement .
2. Remove the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement .
3. Remove the wiper motor module support bracket. Refer to Wiper Motor Module Support Bracket Replacement .
4. Remove the wiper drive system module. Refer to Windshield Wiper Transmission Replacement .

1

Bolt, Windshield Wiper Motor Crank Arm

Tighten
9 N·m (80 lb in)

2

Bolts, Windshield Wiper Motor (Qty: 3)

Tighten
6 N·m (53 lb in)

3

Harness Assembly, Windshield Wiper Motor Wiring

Tip
Disconnect the harness electrical connector from the wiper motor.

4

Motor Assembly, Windshield Wiper

Tip

1. Use the J 39232 or equivalent to separate the transmission arm from the wiper motor crank arm pivot.
2. Use the J 39529 or equivalent to install the transmission arm onto the wiper motor crank arm pivot.