Tools Required

J 39232 Wiper Transmission Separator

1. Remove the wiper arms. Refer to Windshield Wiper Arm Replacement .
2. Remove the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement .
3. Remove the transmission drive link from the wiper motor crank arm using the J 39232 .



4. Remove six screws.



5. Remove the wiper transmission assembly by guiding it through the access hole in the shroud upper panel.

Tools Required

J 39529 Wiper Linkage Installer

1. Position the wiper transmission assembly in the plenum chamber through the shroud upper panel openings.




Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Install the six screws.

Tighten
Tighten the screws to 8 N·m (71 lb in).




3. Install the transmission drive link socket to the wiper motor crank arm ball using the J 39529 .
4. Install the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement .
5. Install the wiper arms. Refer to Windshield Wiper Arm Replacement .