Step
| Action
| Value(s)
| Yes
| No
|
1
| Did you perform the Cruise Control
System Check?
| --
| Go to
Step 2
| Go to
Cruise Control System Check
|
2
|
- Turn the ignition switch to OFF.
- Disconnect the cruise control module connector.
- Turn the ignition switch to RUN.
- Place the CRUISE switch in the ON position.
- Connect a J 39200
digital multimeter (DMM) between terminal E4 of connector C202
and ground.
- Press and hold the R/A switch.
Is the measured voltage within the specified range?
| 10-15V
| Go to
Step 4
| Go to
Step 3
|
3
|
- Inspect the multifunction lever connector for poor terminal contact.
- If the contact is OK, replace the multifunction lever. Refer to
Turn Signal and Multifunction Switch Assembly - Disassemble - Off Vehicle
and to
Turn Signal and Multifunction Switch Assembly - Assemble - Off Vehicle
in Steering Wheel and Column - Tilt.
Is the repair complete?
| --
| Go to
Step 7
| --
|
4
|
- Connect a J 39200
DMM between terminal C of the cruise control module connector
and ground.
- Press and hold the R/A switch.
Is the measured voltage within the specified range?
| 10-15V
| Go to
Step 6
| Go to
Step 5
|
5
| Repair the short
to ground or open in CKT 87 (GRY/BLK).
Is the repair complete?
| --
| Go to
Step 7
| --
|
6
|
- Inspect the cruise control module connector for poor terminal
contact.
- If the contact is OK, replace the cruise control module. Refer
to
Cruise Control Module Replacement
.
Is the repair complete?
| --
| Go to
Step 7
| --
|
7
|
- Ensure that any components removed during diagnosis are installed
in place.
- Ensure that all of the connectors are connected.
- Repeat the system check. Refer to
Cruise Control System Check
.
Is the system check complete?
| --
| System OK
| --
|
