Removal Procedure
- Remove the mirror and
the plastic backing plate by pulling the assembly out of the mirror housing (2).
- Disconnect the electrical connectors.
- Remove the actuator shafts (3) snapped into the mirror
head backing.
Installation Procedure
- Snap the actuator shafts
into the power drive unit.
- Connect the electrical connectors.
- Rotate the actuator shafts (3) in order to align the ears
with the corresponding slots in the back side of the mirror face.
- Align the swivel (4) on the power drive unit (5)
to the pivot points on the mirror backing plate.
- Using the block, perform the following steps:
| 5.1. | Push in the block until a snap is heard. |
| 5.2. | Tilt the mirror toward the upper actuator shaft (3). |
| 5.3. | Apply pressure on the block until the ratchet sound stops. |
| 5.4. | Tilt the mirror toward the outside actuator shaft (3). |
| 5.5. | Apply pressure on the block until the ratchet sound stops. |
- Cycle the mirror for proper operation. If the system is not operating
properly, inspect the actuator shaft alignments.
