Removal Procedure
- Remove the hood insulator.
- Disconnect the electrical connector.
- Apply tape to the edges of the fenders and the hood in order to prevent any paint damage during this procedure.
- Remove the 2 bolts on each side that retain the hinge to the hood.
- Remove the 2 to assist rod clips.
- Remove the hood (1) with the aid of a helper.
Important: Mark the hinge locations on the underside of the hood panel in order to aid in the fore and aft repositioning of the hood when the hood is reinstalled.
Installation Procedure
- With the aid of a helper, place the hood (1) into position. Ensure that the hinges line up with the marks you made during removal.
- Install the 2 bolts on each side in order to retain the hinge to the hood.
- Install the 2 top assist rod clips.
- Adjust the hood, if needed. Refer to Hood Adjustment .
- Touch up any exposed or unpainted surfaces after you replace the hood.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the bolts to 11 N·m (97 lb in).
