Step
| Action
| Value(s)
| Yes
| No
|
1
|
- Turn the ignition switch to the OFF position.
- Disconnect the sunroof control module connector C2.
- Turn the ignition switch to the RUN position.
- Close the sunroof.
- Measure the resistance between connector C2 terminal 8
(RED) and terminal 1 (YEL).
Is the resistance less than the specified value?
| 5 ohms
| Go to
Step 2
| Go to
Step 3
|
2
|
- Open the sunroof.
- Measure the resistance between connector C2 terminal 8
(RED) and terminal 1 (YEL).
Is the resistance equal to the specified value?
| Infinite (OL)
| Go to
Step 4
| Go to
Step 5
|
3
|
- Test CKT 132 (RED) and CKT 133 (YEL) for an open.
- Ensure that the sunroof control module connector C2 is
clean and tight.
- If the connector is OK, replace the sunroof actuator. Refer to
Power Sunroof Motor Replacement
.
Is the repair complete?
| --
| System OK
| --
|
4
| Measure the resistance between connector C2 terminal 8
(RED) and ground.
Is the resistance equal to the specified value?
| Infinite (OL)
| Go to
Step 6
| Go to
Step 7
|
5
| Replace the sunroof actuator. Refer to
Power Sunroof Motor Replacement
.
Is the repair complete?
| --
| System OK
| --
|
6
|
- Ensure that the sunroof control module connector C2 is
clean and tight.
- If the connector is OK, replace the sunroof control module. Refer
to
Power Sunroof Express Module Replacement
.
Is the repair complete?
| --
| System OK
| --
|
7
|
- Test CKT 132 (RED) for a short to ground.
- If CKT 132 is OK, replace the sunroof actuator. Refer to
Power Sunroof Motor Replacement
Is the repair complete?
| --
| System OK
| --
|
