This procedure is for moldings that have not been damaged. Do not use this procedure if the molding is dented or was pried from the body.

Adhesive body side moldings attach with a combination of clips and adhesive tape. Loosen the adhesive prior to disengagement of the molding from the clips. If removed carefully, you may reuse the body side moldings.

1. Thoroughly wash the repair area with Liquid Wash and Wax GM P/N 1052870 or an equivalent.

Wipe the area dry.

2. Remove all traces of adhesive from the body panel and the back of the molding.

Use varnish makers and painters (VM&P) naphtha or isopropyl alcohol.

3. Mark the proper position of the molding with a length of masking tape.

Use the adjacent moldings as a guide.

4. Warm the body panel, using a heat lamp or a heat gun, to a minimum of 21°C (70°F).
5. Apply a piece if gray double-coated foam tape 3M P/N 06380 or an equivalent to the molding.
6. Align the molding to the tape guideline on the body panel.
7. Peel the backing from the end of the molding.
8. Firmly press the molding into place while you continuously remove the backing.
9. Hand roll the molding to the body in order to ensure proper adhesion of the molding.