GM Service Manual Online
For 1990-2009 cars only

Removal Procedure

Tools Required

J 6627-A Wheel Stud Remover

  1. Raise vehicle and suitably support. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Remove the wheel and tire. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  3. Remove the brake rotor. Refer to Front Brake Rotor Replacement in Disc Brakes.

  4. Object Number: 105006  Size: SH
  5. Using press out the wheel stud.
  6. Remove the wheel stud at the inner most notch in the knuckle on the caliper side of the steering knuckle.

Installation Procedure


    Object Number: 105007  Size: SH
  1. Install new wheel stud .
  2. Using washers and a wheel nut, pull the wheel stud in position.
  3. Install the brake rotor. Refer to Front Brake Rotor Replacement in Disc Brakes.
  4. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  5. Install the wheel and tire.
  6. Tighten
    Tighten the wheel nuts to 125 N·m (80 lb ft).

  7. Lower the vehicle.