GM Service Manual Online
For 1990-2009 cars only

Front Brake Caliper Bracket Replacement Without J55

Removal Procedure

  1. Remove the caliper. Refer to Front Brake Caliper Replacement .
  2. Remove the brake pads from the caliper anchor bracket.

  3. Object Number: 450514  Size: SH
  4. Remove the caliper anchor bracket bolts (1).
  5. Remove the anchor bracket.

Installation procedure

Important:  Apply a few drops of GM Loctiteâ„¢ (or equivalent) to the threads of the caliper anchor bracket bolts before installing or replace the bolts with new pre-coated bolts.


    Object Number: 450514  Size: SH
  1. Install the caliper anchor bracket to the steering knuckle (front), or the lower control arm (rear).
  2. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  3. Install the caliper anchor bracket bolts.
  4. Tighten

        • Tighten the front caliper anchor bracket bolts (1) to 185 N·m (137 lb ft).
        • Tighten the rear caliper anchor bracket bolts to 124 N·m (94 lb ft).
  5. Install the brake caliper. Refer to Front Brake Caliper Replacement .

Front Brake Caliper Bracket Replacement J55

Removal Procedure

  1. Remove 2/3 of the brake fluid from the master cylinder.
  2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  3. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  4. Remove the caliper. Refer to Front Brake Caliper Replacement .
  5. Remove the caliper mounting bracket from the steering knuckle assembly. Refer to Front Disc Brake Pads Replacement .

  6. Object Number: 369671  Size: SH
  7. Inspect the caliper mounting bracket. Refer to Brake Caliper Inspection .

Installation Procedure


    Object Number: 369671  Size: SH
  1. Install the caliper mounting bracket to the steering knuckle assembly. Refer to Front Disc Brake Pads Replacement .
  2. Install the caliper. Refer to Front Brake Caliper Replacement .
  3. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  4. Remove the safety stands.
  5. Lower the vehicle.
  6. Pump the brake pedal slowly and firmly in order to seat the brake pads.