Removal Procedure
Important: Before replacing the RIM module, record the personalization settings
in order to restore the settings after the new module is installed.
- Record the RIM personalization settings. Refer to
Body Control Module (BCM) Programming/RPO Configuration
.
- Remove the rear storage
compartment trim. Refer to
Rear Compartment Front Trim Panel Replacement
in Body Rear End.
- Remove the bay board fasteners (2).
- Pull the bay board (1) away from the body and place the
bay board (1) module side up in the rear compartment.
- Disconnect the RIM (1)
electrical connectors.
- Depress inward on the locking tabs (2).
- With the locking tabs (2) depressed, slide the RIM (1)
out of the bay board
- Remove the RIM module (1) from the bay board.
Installation Procedure
- Install the RIM module (1)
to the bay board.
- Push the RIM (1) into the bay board until an audible click
is heard indicating the locking tabs are fully engaged.
- Connect the RIM (1) electrical connectors.
- Install the bay board (1) to the vehicle body.
Notice: Use the correct fastener in the correct location. Replacement fasteners
must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant
are identified in the service procedure. Do not use paints, lubricants, or
corrosion inhibitors on fasteners or fastener joint surfaces unless specified.
These coatings affect fastener torque and joint clamping force and may damage
the fastener. Use the correct tightening sequence and specifications when
installing fasteners in order to avoid damage to parts and systems.
- Install the bay
board fasteners (2).
Tighten
Tighten the fasteners (2) to 9 Nยทm (80 lb in).
- Install the rear compartment trim. Refer to
Rear Compartment Front Trim Panel Replacement
in Body Rear End.
- Program the body control module and restore the personalization
settings. Refer to
Body Control Module (BCM) Programming/RPO Configuration
.