GM Service Manual Online
For 1990-2009 cars only

Important: Never swap OnStar® vehicle integration units (VIU), or the vehicle communication units (VCU) from other vehicles. Transfer of OnStar® components from other vehicles should NOT be done. Each OnStar® component has a unique identification number. The VIU has a 10-digit specific station identification (STID) and the VCU has a 11-digit specific electronic serial number (ESN). These identification numbers are used by the National Cellular Telephone Network and OnStar® systems, and are stored in the General Motors vehicle history files by VIN.

Removal Procedure


    Object Number: 625727  Size: SH
  1. Remove the rear compartment trim. Refer to Rear Compartment Front Trim Panel Replacement in Body Rear End.
  2. Remove the mounting bracket fasteners (2).
  3. Pull the mounting bracket (1) away from the body and place the mounting bracket  (1), module side-up, in the rear compartment.

  4. Object Number: 702924  Size: SH
  5. Remove the VCU/VIU from the mounting bracket by releasing the module retaining tab (1). Pull the module up and out of the mounting bracket (1).

  6. Object Number: 649484  Size: SH
  7. Remove the VIU/VCU modules (2) from the mounting bracket (1).
  8. Disconnect the antenna and the electrical connections from the VCU/VIU assembly (2).

  9. Object Number: 649490  Size: SH
  10. Slide the VCU/VIU assembly (2) out of the mounting bracket (1).

  11. Object Number: 649495  Size: SH
  12. Remove the fasteners retaining the VCU mounting bracket (1) to the VIU (2).
  13. Remove the mounting bracket (1) from the VIU (2).
  14. The old VIU must be returned for core credit.

Installation Procedure


    Object Number: 649495  Size: SH
  1. Install the VCU mounting bracket (1) to the VIU (2).
  2. Notice: Refer to Fastener Notice in the Preface section.

  3. Install the fasteners in order to secure the mounting bracket (1) to the VIU (2).
  4. Tighten
    Tighten the fasteners to 2 N·m (18 lb in).


    Object Number: 649490  Size: SH
  5. Install the VCU (2) to the VIU and bracket assembly (1).

  6. Object Number: 649484  Size: SH

    Notice: In order to avoid damage to the circuit board, do NOT over-tighten the thumb screws. Using your fingers, apply only a light pressure.

    Important: Connect the electrical connector.

  7. Apply than 0.2 N·m (2 lb in) of torque, or less, to the VIU thumb screw electrical connections.
  8. Install the VIU /VCU assembly (2) to the mounting bracket (1).

  9. Object Number: 702924  Size: SH
  10. Push in on the top of the module assembly until an audible click is heard. This click indicates that the mounting tab (1) has fastened the VIU/VCU securely to the bay board.

  11. Object Number: 625727  Size: SH
  12. Install the mounting bracket (1) to the vehicle body.
  13. Install the mounting bracket fasteners (2).
  14. Tighten
    Tighten the fasteners (2) to 9 N·m (80 lb in).

  15. Install the rear compartment trim. Refer to Rear Compartment Front Trim Panel Replacement .
  16. Reconfigure the OnStar® system. Refer to OnStar Reconfiguration .
  17. The 10-digit STID number recorded will be needed by the OnStar® Dealer Support line.