GM Service Manual Online
For 1990-2009 cars only

Step

Action

Value(s)

Yes

No

1

Did you review the Wiper/Washer System Description and Operation and perform the necessary inspections?

--

Go to Step 2

Go to Symptoms

2

  1. Disconnect the harness connector from the wiper motor.
  2. Turn the ignition switch ON.
  3. Set the wiper switch to LO.
  4. Connect a test lamp between the wiper speed input circuit of the wiper motor connector and a good ground.

Does the test lamp illuminate?

--

Go to Step 6

Go to Step 3

3

Test the wiper speed input circuit for an open. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.

Did you find and correct the condition?

--

Go to Step 8

Go to Step 4

4

Inspect for poor connections at the harness connector of the wiper/washer switch. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.

Did you find and correct the condition?

--

Go to Step 8

Go to Step 5

5

Replace the wiper/washer switch. Refer to Multifunction, Turn Signal, and Hazard Switch Replacement - On Vehicle .

Is the replacement complete?

--

Go to Step 8

--

6

Inspect for poor connections at the harness connector of the wiper motor. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.

Did you find and correct the condition?

--

Go to Step 8

Go to Step 7

7

Replace the wiper motor. Refer to Windshield Wiper Motor Replacement .

Is the replacement complete?

--

Go to Step 8

--

8

Operate the wiper/washer system and inspect for proper operation.

Did you correct the condition?

--

System OK

Go to Symptoms