GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Cadillac 🢒 2000 🢒 DeVille 🢒 Body and Accessories 🢒 Instrument Panel, Gauges, and Console 🢒 Diagnostic System Check - Instrument Cluster

Test Description

The number(s) below refer to the step number(s) on the diagnostic table.

  1. Lack of communication may be due to a partial malfunction of the class 2 serial data circuit or due to a total malfunction of the class 2 serial data circuit. The specified procedure will determine the particular condition.

    2.

  2. The symptom list in Symptoms will determine the correct diagnostic procedure to use.

    3.

  3. The presence of DTCs which begin with "U" indicate some other module is not communicating. The specified procedure will compile all the available information before tests are performed.

Step

Action

Yes

No

1

Install a scan tool.

Does the scan tool power up?

Go to Step 2

Go to Scan Tool Does Not Power Up in Data Link Communications

2

  1. Turn ON the ignition, with the engine OFF.
  2. Attempt to establish communication with the following control modules:
    3. • Instrument cluster (IPC)
    • Powertrain control module (PCM)
    • Electronic brake control module (EBCM)
    • Inflatable restraint sensing and diagnostic module (SDM)
    • Dash integration module (DIM)
    • Rear integration module (RIM)
    • Instrument panel integration module (IPM)
    • Theft deterrent module
    • Driver door module (DDM)
    • Passenger door module (PDM)
    • Left rear door module (LRDM)
    • Right rear door module (RRDM)

Does the scan tool communicate with the control modules listed above?

Go to Step 3

Go to Scan Tool Does Not Communicate with Class 2 Device in Data Link Communications

3

Select the display DTCs function on the scan tool for the following control modules:

    • Instrument cluster (IPC)
    • Powertrain control module (PCM)
    • Electronic brake control module (EBCM)
    • Inflatable restraint sensing and diagnostic module (SDM)
    • Dash integration module (DIM)
    • Rear integration module (RIM)
    • Instrument panel integration module (IPM)
    • Theft deterrent module
    • Driver door module (DDM)
    • Passenger door module (PDM)
    • Left rear door module (LRDM)
    • Right rear door module (RRDM)

Does the scan tool display any DTCs for the control modules listed above?

Go to Step 4

Go to Symptoms - Instrument Cluster

4

Does the scan tool display any DTCs which begin with a "U"?

Go to Scan Tool Does Not Communicate with Class 2 Device in Data Link Communications

Go to Diagnostic Trouble Code (DTC) List - Instrument Cluster/Driver Information System