Theft Deterrent System Inoperative
Step
| Action
| Value(s)
| Yes
| No
|
DEFINITION: The CTD system will not ARM or DISARM properly.
|
1
| Was the
Theft Deterrent System Diagnostic System Check performed?
| --
| Go to
Step 2
| Go to
Diagnostic System Check - Theft Deterrent
|
2
|
- Turn OFF the ignition.
- Open the driver or passenger door.
- Press the driver or passenger power door lock switch.
- Close both the driver and passenger doors (CTD System is now ARMED).
Does the CTD system ARM properly?
| --
| Go to
Step 3
| Go to
Go to
Step 6
|
3
| Disarm the CTD system
by inserting the door key into the driver door lock cylinder and rotate it
to the unlock position, then try the passenger door lock cylinder.
Does the CTD system DISARM properly from both doors?
| --
| Go to
Step 7
| Go to
Step 4
|
4
| Disarm the
CTD system by pressing the UNLOCK button on the remote transmitter.
Does the CTD system DISARM properly?
| --
| Go to
Diagnostic System Check - Power Door Systems
| Go to
Step 5
|
5
| Using a scan tool, try to establish
communications with the following modules:
• | Dash Intergration Module (DIM) |
• | Driver Door Module (DDM) |
• | LH Middle Door Module (w/V4U) |
• | Passenger Door Module (PDM) |
• | Rear Integration Module (RIM) |
• | RH Middle Door Module (w/V4U) |
Can the scan tool communicate with all the modules?
| --
| Go to
Step 7
| Go to
Scan Tool Does Not Communicate with Class 2 Device
|
6
|
- Turn OFF the ignition.
- Close the driver and passenger doors.
- Press the LOCK button on the remote transmitter.
Does the CTD system ARM properly?
| --
| Go to
Diagnostic System Check - Power Door Systems
| Go to
Step 5
|
7
| Inspect the following circuits for an intermittent malfunction:
• | Driver door ajar switch |
• | Passenger door ajar switches |
• | Intermittent communications between the DIM, LFDM, or RIM systems |
• | Power door lock switches |
• | Door lock cylinder switches |
• | Hood ajar switch (export only) |
Did you find and correct the condition?
| --
| Go to
Step 9
| Go to
Step 8
|
8
|
- Replace the RIM. Refer to Body Control Module Replacement in Body
Control System.
- Program the RIM.
Is the replacement complete?
| --
| Go to
Step 9
| --
|
9
|
- Turn OFF the ignition.
- Reconnect or install any connectors or components that were disconnected
or removed.
Is the repair complete?
| --
| Go to
Diagnostic System Check - Theft Deterrent
| --
|