Test Description
The number(s) below refer to the step number(s) on the diagnostic table.
Important: Make sure that the passenger window lockout option is selected as ON in the vehicle owner customization menu.
If the window lockout selection is OFF, set it to ON and verify that the fault is still present.Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
|
Important: Make sure that the passenger window lockout option is selected as ON in the vehicle owner customization menu. If the window lockout selection is OFF, set it to ON and verify that the fault is still present. This test assumes that all DTCs have been diagnosed. | ||||
1 | Did you Perform the Door Systems Diagnostic System Check? | -- | Go to Step 2 | |
2 |
Does the scan tool display Lock and Idle as expected? | -- | Go to Step 3 | Go to Step 6 |
Observe the lockout LED indicator on the lockout switch button, and the Window Lockout SW.-Dr parameter on the scan tool, while activating the lockout switch to both the Lock and Idle positions. Does the LED indicator illuminate when the lockout switch is activated to the Lock position, and go out when the lockout switch is activated to the Idle position as expected? | -- | Go to Step 4 | Go to Step 6 | |
4 |
Did each rear window still operate from it's associated window switch? | -- | Go to Step 6 | Go to Step 5 |
5 | Did only one of the rear windows operate in step 4? | -- | Go to Step 7 | Go to Testing for Intermittent Conditions and Poor Connections |
6 | Inspect for poor connections at the driver door switch assembly harness connector. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems. Did you find and correct the conditon? | -- | Go to Step 10 | Go to Step 8 |
7 | Inspect for poor connections at the door module harness connector of the module associated with the window that continued to operate. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems. Did you find and correct the conditon? | -- | Go to Step 10 | Go to Step 9 |
8 | Replace the driver door switch assembly (DDSA). Refer to Front Door Switch Replacement . Did you complete the replacement? | -- | Go to Step 10 | -- |
9 | Replace the door module associated with the window that continued to operate. Refer to Door Control Module Replacement . Did you complete the replacement? | -- | Go to Step 10 | -- |
10 | Operate the system in order to verify the repair. Did you correct the condition? | -- | System OK | Go to Step 2 |
