Did you perform the Diagnostic System Check - Power Door Systems?

--

Go to Step 2

Go to Diagnostic System Check - Power Door Systems

1. Check to see that the mirror Curb View personalization function has been enabled.
2. If the Curb View personalization function is not already enabled, enable it.
3. Turn ON the ignition, with the engine OFF.
4. Shift the transmission into Reverse.

Does the mirror on the passenger front door tilt down?

--

Go to Step 8

Go to Step 3

3

1. Install a scan tool
2. Turn ON the ignition, with the engine OFF.
3. With the mirror select switch, select the R mirror.
4. With the mirror position adjustment switch, move the passenger front door mirror.
5. With the scan tool observe the Sensor parameters in the Data list of the Passenger Front Door module.

Did the Sensor values change?

--

Go to Step 4

Go to Step 5

Inspect for poor connections at the harness connector of the outside rear view mirror. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.

Did you find and correct the condition?

--

Go to Step 8

Go to Step 7

Inspect for poor connections at the harness connector of the outside rear view mirror. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.

Did you find and correct the condition?

--

Go to Step 8

Go to Step 6

Replace the inoperative outside rear view mirror. Refer to Power Mirror Replacement .

Did you complete the replacement?

--

Go to Step 8

--

Replace the door module of the inoperative mirror. Refer to Door Control Module Replacement .

Did you complete the replacement?

--

Go to Step 8

--

Operate the system in order to verify the repair.

Did you correct the condition?

--

System OK

Go to Step 2