Removal Procedure
- Remove the front bucket seat. Refer to
Bucket Seat Replacement
.
- Remove the seat bottom and frame assembly. Refer to
Front Seat Cushion Replacement
.
- If the cable is equipped with a position sensor, remove the sensor
retention clip and disconnect the electrical connector.
- Remove the drive motor fasteners in order to allow cable to be
removed without damaging the drive cable.
- Squeeze the collar of
the cable in order to release the cable.
- Pull the cable out of
the fitting until the cable end clears the fitting.
- Remove the cable or cable/sensor assembly.
Installation Procedure
- Install the cable or cable/sensor
assembly by pushing the ends into the fittings until the clip snaps into
place.
- If the cable is equipped with a position sensor, install the sensor
retention clip and connect the electrical connector.
- Install the drive motor fasteners.
- Install the seat bottom and frame assembly. Refer to
Front Seat Cushion Replacement
.
- Install the front bucket seat. Refer to
Bucket Seat Replacement
.