Tools Required

Caution: Do not move the vehicle until a firm brake pedal is obtained. Air in the brake system can cause loss of brakes with possible personal injury.

Caution: Use only SUPREME 11 or equivalent DOT 3 brake fluid from a clean, sealed container. Do not use fluid from an open container that may be contaminated with water. Improper or contaminated fluid will result in damage to components or loss of braking, with possible personal injury.

Notice: Avoid spilling brake fluid on any of the vehicle's painted surfaces, wiring, cables or electrical connectors. Brake fluid will damage paint and electrical connections. If any fluid is spilled on the vehicle, immediately flush the area with water to minimize the potential for damage.

1. Remove the master cylinder reservoir cap. Replace it with the J 35589 .
2. Charge the bleeder to 210-245 kPa (30-35 psi).
3. Connect the hose to the J 35589 .
4. Raise the vehicle and support. Refer to Lifting and Jacking the Vehicle in General Information.



5. If it is necessary to bleed all of the brake calipers, the following sequence should be used:

5.1.	Right rear

5.2.

Left rear

5.3.	Right front

5.4.	Left front

6. Place the proper size box end wrench, or equivalent, over the brake caliper bleed screw. Attach a clear tube over the screw and allow the tube to hang submerged in a clear container partially filled with brake fluid.
7. Open the brake caliper bleed screw at least ¾ of a turn and allow the brake fluid flow to continue until no air is seen in the brake fluid. Apply intermittent pressure to the brake pedal while pressure bleeding.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

8. Close the brake caliper bleed screw.

Tighten
Tighten the brake caliper bleed screw to 13 N·m (110 lb in).

9. Repeat steps 6 through 8 until all of the calipers have been bled.
10. Lower the vehicle.
11. When pressure bleeding is completed, bleed the brake system using a Scan Tool. Refer to Antilock Brake System Automated Bleed Procedure in Antilock Brake System.
12. Remove the brake bleeding equipment from the master cylinder.