Circuit Description
The steering column tilt/telescoping module (SCCM) provides a 5 volt reference voltage to the tilt position sensor circuits and the telescope position sensor circuits. The SCCM uses internal circuits connected to the source voltage to determine if the 5 volt reference voltage is within a valid range.
Conditions for Running the DTC
The self diagnostic test will run once every 30 seconds regardless of source voltage.
Conditions for Setting the DTC
If the 5 volt reference voltage falls out of the range of 4.6 volts to 5.2 volts for 1.2 seconds the sccm will set the code.
Action Taken When the DTC Sets
Will not allow memory recall functions.
Conditions for Clearing the DTC
The SCCM no longer detects a failure during the last self diagnostic test.
Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
1 | Did you perform the Tilt/Telescoping Steering Column Diagnostic System check? | -- | Go to Step 2 | Go to Tilt/Telescoping Steering Column Diagnostic System Check |
2 |
Important:: Perform the set up procedure for the tilt/telescoping steering column control module Replace the tilt/telescoping steering column control module. Refer to Steering Column Control Module Replacement Did you complete the replacement? | -- | System OK | -- |
