ASHTRAY REPL. PROCEDURES AND SERVICE PART NUMBER
SUBJECT: INFORMATION ON ASHTRAY REPLACEMENT PROCEDURES AND SERVICE PART NUMBERS
VEHICLES AFFECTED: 1992-93 "E" AND "K" MODELS
This bulletin is being revised to update warranty information. Warranty Administration has been notified of all changes and the warranty claims processing system has been updated.
This bulletin includes service part numbers for the console ashtray assembly and describes a procedure for console ashtray replacement for 1992-93 E and K models. It is no longer necessary to replace the entire console trim plate assembly to service console ashtray components.
Ashtray Service Part Numbers:
Included below and in Figure 1 is a summary of GMSPO service part numbers for the ashtray assembly and component parts. Please note the following items:
o Console trim plates are serviced as complete assemblies by colour (vinyl trim plates) and in wood grain (zebrano and mahogany). Trim plate assemblies include all ashtray components including cigar lighter components, electrical harness, and connector's.
o Ashtray door trim should be transferred to the new ashtray assembly as described in the procedure below.
o Ashtray components serviced separately include the following items. Refer to the current GMSPO parts catalog for complete console trim plate assembly part numbers.
Description Part Number
Ash Receiver. 3533074 Ashtray Assembly. 3536661 Ashtray Follower Arm (Latch). 3543470 Ashtray Hamess. 12098861 Cigar Lighter. 3521568
Ashtray Replacement Procedure:
Should front console ashtray replacement become necessary, use the following procedure. This procedure will be included in an upcoming revision of the 1993 Eldorado/Seville Service Information Manual.
1. Remove radio trim plate. Refer to Figure 1.
2. Turn ignition to "OFF" position and move shift lever to "REVERSE". Remove console trim plate by disengaging five clips. Position trim plate to again access to ashtray harness connector. Refer to Figure 2.
3. Disconnect ashtray harness and remove trim plate from car.
NOTE: It is not necessary to remove shift handle from shifter assembly to remove trim plate from vehicle.
4. Remove ashtray housing from trim plate by removing four screws.
5. Using a flat-bladed screwdriver or knife carefully pry the ashtray door trim from the ashtray housing assembly. The ashtray door trim is located on the housing by tabs and is held in position by RTV silicone adhesive.
6. Remove excess old RTV silicone adhesive from the back of the ashtray door trim with a sharp knife or razor blade.
7. Apply a thick bead of GM RTV silicone adhesive, P/N 1052751, to the back of ashtray door trim. Adhesive bead must be at least 32mm (1-1/4 inch) in diameter. Install trim on ashtray assembly and secure with tape. Be sure ashtray door trim is properly aligned.
8. Allow adhesive to cure at least 12 hours before installing ashtray on console trim plate.
9. After adhesive has cured, install ashtray assembly on the console trim plate.
10. Install console trim plate in vehicle.
General Motors bulletins are intended for use by professional technicians, not a "do-it-yourselfer". They are written to inform those technicians of conditions that may occur on some vehicles, or to provide information that could assist in the proper service of a vehicle. Properly trained technicians have the equipment, tools, safety instructions and know-how to do a job properly and safely. If a condition is described, do not assume that the bulletin applies to your vehicle, or that your vehicle will have that condition. See a General Motors dealer servicing your brand of General Motors vehicle for information on whether your vehicle may benefit from the information.
