GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Cadillac 🢒 2002 🢒 Eldorado 🢒 Suspension 🢒 Rear Suspension 🢒 Stabilizer Shaft Insulator Replacement

Removal Procedure
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.

    2. Object Number: 721295 Size: SH
  2. Remove the stabilizer shaft bracket bolt.

    3. Object Number: 721291 Size: SH
  3. Remove the stabilizer shaft bracket.
  4. Remove the stabilizer shaft insulator from the stabilizer shaft.

Installation Procedure

    Object Number: 721291 Size: SH
  1. Install the stabilizer shaft insulator to the stabilizer shaft.
  2. Install the stabilizer shaft bracket to the stabilizer shaft.

    3. Object Number: 721295 Size: SH
  3. Install the stabilizer shaft bracket bolt.

    4. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  4. Tighten the stabilizer shaft bracket bolt.

    5. Tighten
    Tighten the stabilizer shaft bracket bolt to 60 N·m (44 lb ft).

  5. Lower the vehicle.