Sunroof Replacement CF5

Notice: To avoid paint damage, protect the area surrounding the part which you are removing or installing.




1. Lower the headliner. Refer to Headlining Trim Panel Replacement in Interior Trim.
2. Cycle the glass panel to the rear.

Important: Do not remove the fine-thread machine fasteners (4) second from the rear. Identify the fasteners from the inside of the vehicle.

3. Remove the fasteners (2) from the cover plates. Start with the rear most fastener on both sides.
4. Cycle the glass panel to the flush or closed position.
5. Remove the motor. Refer to Power Sunroof Motor Replacement .



6. Remove the 2 sunroof motor bolts (4) at the front of the sunroof housing.




Important: 

•	To prevent damage to the finish, mask the roof panel in front of the sunroof opening using masking tape and paper.

•	Carefully handle the module by the glass panel. Do not squeeze the module or bend the components.

7. Remove the sunroof module (1) by lifting upward and forward.

1. Insert the rear of the module through the roof opening (2). Index the module on the raised guides on the track.
2. Slide the module (1) into the sunroof opening. Do not damage the finish at the front of the opening.

As you slide the module under the rear retaining clips (3), you will feel resistance during the last 6-9 cm (2-3 in) of travel.

3. Verify that the module (1) is under the clips. This will prevent noise during travel over road irregularities.
4. Lower the glass panel into the opening.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.




5. Install the 2 bolts (4) in the sunroof motor.

Tighten
Tighten the 2 bolts to 3 N·m (27 lb in).

6. Install the motor. Refer to Power Sunroof Motor Replacement .
7. Cycle the glass panel full rearward.
8. Cycle the glass panel forward 3 mm (0.125 in) in order to remove the load from the bumpers.



9. Install the 2 rear bolts (one per side) in the module (3) in order to align the unit.
10. Install the 6 bolts (2).

Tighten
Tighten the bolts to 3 N·m (27 lb in).

11. Inspect for the following conditions:

•	Proper operation

•	Proper fit

•	Synchronization

12. Install the headliner. Refer to Headlining Trim Panel Replacement in Interior Trim.