GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Cadillac 🢒 2002 🢒 Eldorado 🢒 Body and Accessories 🢒 Exterior Trim 🢒 Door Body Side Molding Replacement

Removal Procedure
  1. Open the door.

    2. Object Number: 370942 Size: SH
  2. Remove the screw (2).
  3. Remove the nut (5).
  4. Unsnap the lower edge of the molding (3) off of the retaining clips (1).
  5. Remove the molding.

Installation Procedure

    Object Number: 370942 Size: SH
  1. Position the molding (3) over the top of the retaining clips (1).
  2. Install the molding to the front door with a nut.
  3. Insert the stud at the front of the molding into the slot in the door.
  4. Snap the molding (3) over the lower portion of the clips (1).
  5. Open the door.
  6. For the fore/aft alignment, align the upper rear corner of the molding with the door hem flange.

    7. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  7. Install the nut (5).

    8. Tighten
    Tighten the nut to 2 N·m (18 lb in).

  8. Secure the rear of the molding with a screw.
  9. Install the screw (2).

    10. Tighten
    Tighten the screw to 1.5 N·m (13 lb in).

  10. Close the door.